Installation steps of LED explosion-proof lights

LED explosion-proof light is a kind of lighting equipment specially designed for hazardous areas. When installing LED explosion-proof lights, the following steps need to be followed:

1. Prepare tools and materials. Installing LED explosion-proof lights requires the use of tools and materials, such as screwdrivers, wrenches, wires, wire clips, etc.

2. Confirm the installation location. Before installing the LED explosion-proof lamp, you need to confirm its installation location. Usually, LED explosion-proof lights need to be installed on the top or side of the hazardous area.

3. Fix the bracket. Fix the bracket on the LED explosion-proof light and install it in the predetermined position.

4. Wiring. Feed the wires through the light body through the brackets and secure the wires with wire clips. Then connect the wires to the power supply.

5. Install the lampshade. Install the lampshade of the LED explosion-proof lamp to ensure that the lampshade is firm and sealed with the lamp body.

6. Test the lights. Connect the LED explosion-proof light to the power source and test whether it lights up properly.

7. Adjust the light angle. Adjust the light angle of the LED explosion-proof light as needed.

The above are the basic steps for the installation of LED explosion-proof lights. During the installation process, please be sure to read the instruction manual carefully to ensure correct installation to avoid safety accidents.